Flex Pipe USA
Dayton, MN | [email protected] | 763-200-2287
Engineering Submittal
Ref ID: FP-MH-321-304-FNPTU-FNPTU
| PROJECT: ___________________________________ | DATE: October 11, 2026 |
| LOCATION: _________________________________ | SUBMITTAL #: ____________ |
| ENGINEER: _________________________________ | REVISION: Rev 0 |
| CONTRACTOR: _______________________________ | DRAWING REF: __________ |
ENGINEER APPROVAL STAMP
BY: ____________ DATE: ______
1. Assembly Description & Identification
321SS Braided Metal Hose – Carbon Steel 150# Female NPT Union Ends
Flexible connector designed for easy servicing and disconnect in mechanical and hydronic piping systems. Features a 321 stainless steel annular corrugated hose core, a single 304 stainless steel braid, and carbon steel 150# Female NPT union fittings on both ends.

Assembly Detail
2. Materials & Construction
- Corrugated Hose Core: 321 Stainless Steel (Annular)
- Outer Braid: 304 Stainless Steel (Single Layer)
- End Fittings (Side A & B): Carbon Steel 150# FNPT Union
- Union Seating: Ground Joint Metal-to-Metal Seat
- Terminations: TIG Welded Construction
3. Operating Limitations
- Max Temperature: +450°F (Union Fitting Limited)
- Testing Standard: 100% Hydrostatic Test to 1.5x MAWP
- Design Standards: EJMA Standards & ASME B31.3
- Service: Water, glycol, steam, hot/chilled hydronics
4. Dimensional & Pressure Rating Matrix
| Hose ID (NPS) | MAWP @ 70°F (Max. Allowed Working Pressure) |
MAWP @ 300°F (Max. Allowed Working Pressure) |
Min. Dynamic Bend Radius | Standard Online OAL |
|---|---|---|---|---|
| 0.50 in. (15mm) | 150 PSI | 130 PSI | 8.0 in. | 12 in. through 72 in. |
| 0.75 in. (20mm) | 150 PSI | 130 PSI | 9.0 in. | 12 in. through 72 in. |
| 1.00 in. (25mm) | 150 PSI | 130 PSI | 10.0 in. | 12 in. through 72 in. |
| 1.25 in. (32mm) | 150 PSI | 130 PSI | 11.0 in. | 12 in. through 72 in. |
| 1.50 in. (40mm) | 150 PSI | 130 PSI | 12.0 in. | 12 in. through 72 in. |
| 2.00 in. (50mm) | 150 PSI | 130 PSI | 14.0 in. | 12 in. through 72 in. |
INSTALLATION REQUIREMENT: Tighten union ground joints using proper pipe wrenches. Do not transmit installation torque into the corrugated metal hose body.
5. Quality Assurance & Certification
All assemblies are 100% leak tested prior to release. Material Test Reports (MTRs) and Hydrostatic Test Certificates are supplied upon request.
